STEP 3
SOURCE A PUMP With your stock tank picked out and a plan for delivery, figure out what type of pump you’ll be using for your pool. One common option is a traditional pump with paper filters you replace frequently. This type of pump requires a bit more attention and you’ll need to remember to order filters and replace them on a regular schedule. You’ll also have more waste from discarded filters. However, this type of pump is more budget- friendly than other options. Another common type of pump is a sand pump. These pumps rely on sand or ground up glass to filter so there is little waste and the sand only needs replaced every few years. Over the life of the pump, it will average out to a lower cost than a cartridge setup.
STEP 4
CONSIDER POWER SOURCE Your pump needs power so figure out where you’ll be plugging it in. If you’re close enough to the house, you may be able to plug it directly into an exterior outlet. However, if you’re not within reach (generally around six feet), you’ll need to use an extension cord or install a tower electrical outlet. Just make sure you have a plan before installation.
STEP 5
HEAT IT UP (OPTIONAL) We rely on pools to cool us down, but sometimes the chilly water is too much of a good thing. If you want to provide a heater for your pool, there are myriad ways to go about it. You can invest in a solar, electric, or propane heater to do the job. If this is part of your plan, now is the time to source supplies and map out the blueprint.
14
HOME SWEET HOME Magazine
Powered by FlippingBook